1971 Chevelle L-s 5 Lime Green 454 Racing Strips We Ship World Wide on 2040-cars

Auto blog

Chevrolet To Oversee Restoring Sinkhole Corvettes

What Mother Earth devoured, Chevrolet plans to resurrect. The carmaker said Thursday it will oversee restoration of the classic cars swallowed by a huge sinkhole beneath the National Corvette Museum in Kentucky. General Motors Design in Warren, Mich., will manage the painstaking work to repair the eight prize vehicles, the automaker said Thursday. The cars were consumed when the earth opened up early Wednesday beneath a display area when the museum in Bowling Green, Ky., was closed. No injuries were reported. The museum was open Thursday except for the area where the sinkhole occurred. Mark Reuss, GM's head of global product development, said the damaged vehicles rank as "some of the most significant in automotive history." "There can only be one 1-millionth Corvette ever built," he said, referring to one of the damaged cars. "We want to ensure as many of the damaged cars are restored as possible so fans from around the world can enjoy them." Just how the cars will be pulled out of the ground remains to be seen, said museum executive director Wendell Strode. The local fire department estimated the hole is about 40 feet across and 25 to 30 feet deep. The hole opened beneath part of the museum's domed section. "We feel pretty confident that most of the cars can be extracted," Strode said Thursday. "And we hope and believe that with just a little bit of luck, that all eight cars can be extracted and be part of the restoration." Chevrolet spokesman Monte Doran said some of the cars look to be in good shape, while others are buried in rubble. "It will likely be several weeks until we can get the cars out and assessed," he said. The GM Design team has helped restore other historic cars, but the Corvette project looks to be its biggest, he said. "These Corvettes are part of our history, and they want them restored properly," Strode said. "We're thrilled they're doing this." The cars looked like toys as they plunged into the hole, piled in a heap amid dirt and concrete fragments. The museum owns six of the cars while two - a 1993 ZR-1 Spyder and a 2009 ZR1 Blue Devil - are on loan from General Motors. The other cars damaged were a 1962 black Corvette, a 1984 PPG Pace Car, a 1992 White 1 Millionth Corvette, a 1993 Ruby Red 40th Anniversary Corvette, a 2001 Mallett Hammer Z06 Corvette and a 2009 white 1.5 Millionth Corvette. Pictures of the sinkhole showed a collapsed section of floor with multiple cars visible inside the hole.

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.