Find or Sell Used Cars, Trucks, and SUVs in USA

1969 Chevelle 350 Matching 1 Owner Restoration New Parts/metal Frame Off L@@k! on 2040-cars

Year:1969 Mileage:234000 Color: azure torquis /
 White
Location:

Henderson, Nevada, United States

Henderson, Nevada, United States
Transmission:Automatic
Body Type:Coupe
Vehicle Title:Clear
Engine:350
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: 136379z347699 Year: 1969
Number of Cylinders: 8
Make: Chevrolet
Model: Chevelle
Trim: no SS 350 PS & AC
Power Options: Air Conditioning
Drive Type: auto - 350
Mileage: 234,000
Sub Model: mailbu
Disability Equipped: No
Exterior Color: azure torquis
Warranty: none
Interior Color: White
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"NOT RUNNING . dismanteled , rust free new roof rear 1/4's & fenders . in 1st primer coat."

This is a one owner 1969 Malibu Chevelle with factory matching # 350 PS , PB & AC , auto 350 tranny... was purchase by me in 9/12 of last year from origional owner . i paid $3800.It was a good deal but the vinyl top was rusted through really bad as was the deck. That was the only rust on the car it was a CALIFORNIA car  . origional engine leaked &. It was retired in 1990 had 200K . Factory GM replacement was installed at chevy.Both engines are included will get back to them. Because the roof area was the only rusted area & the rear 1/4's were repaired & had bondo & front fenders had danage. the right thing to do was replace them all the are all goodmark sheetmetal  They are cut , welded , grinded, smoothed & just just need to be caulked/sealed on the edges. The drip rails bcz of the vynal top the edges need to be covered with a chrome rail accent. The body is 98% straight needs to be lined up primed & a nice finish coat of azure torquise should do 2 stage with clear. So while the 1/4's & roof were off , all the surface rust was wire wheeled off & repainted. same as the frame. . This was sprayed on with a oil based gloss black paint (rustolium from home depot) I was unable to get powder-coated due to budget. It looks really nice engine bay,dash & underside is fresh paint. I did put some new parts when it was apart.

Chrome hood hindges & old one too. Now has 12 bolt (had non-posi)  now has front Disc brakes & new brake hoses hardware .Dual exhust & chrome smaller power brake booster  (from 70 montycarlo SS  i parted out & keep them for the chevelle) New E brake & speedo cable. all origional suspension is  replaced uppers,lowers rfont & rear including the A arm bumpers  , Tranny was running perfect so that is cleaned new gasket & pan painted chevy orange. I have the fluid to refill too.. All the glass is there accept front windshield isnt (cost $160) driver window has some scratches. all interior is origional bench seat door panels  everything is removed w/o any rubber or glass in doors or window felt. the interior kit is about $1500 . 


The engine : well actually it's 2 engines you get. the first one is a 1990 GM 350 that is intact & coulld be put back into the car. The parts really need to be removed & put on the matching 350 4 bolt main that came out origionaly. Its 1/2 completed. dipped & standard boar new rebuild kit with new cam, pistons & 2 cranks  (old one has broken bolt  & new one is in box. The heads are rebuilt. old radiator i have but will include my idea on the cooling was to do a aluminum racing radatior & electric fan . New in box hooker headers & chrome oil pan,vintage edlebrock aluminum manifold & new chrome valve covers & chrome ez off bolts. .Switching out the other parts from the old non stock engine.& dressing up the origional block.  resell or use the 1990 350 for another project its easily worth $750)  

It comes with both bumpers straight & decent chrome, 2 sets of tail lenses , jack some extra parts .white interior dupont vinyl roll of upholstry for the rear deck or to wrap the dash pad. . extra keys , new power steering pump. The harrison radio & a/c controls need to be instaled or you might replaced it was cracked repaired & painted the black like everything else. steering wheel is also cracked too . it is not a tilt . If you want to make it a SS that would be changed anyway.  Tire were 14's now there after market 15" rally rims with roller tires no center hubs 3 accent rings.  Entire undercarriage is perfect. The dual exhust are from the monty  (they're 6 inches longer) they need to be cut & connected to the new hooker headers. its under the car already. I still have the single exhust & headers to include if wanted . 
 
The is a one time listing if it doesnt sell for the listed price or i will have to complete the project. I'm only selling for stupid reasons . Time to finish-labor hours., moneys tight needs about 4K minium to finish paint-engine & interior - new grille & chrome in a few places. My son just started college and wants no part of the restoration project anymore & wants to educate himself. so if it sells for what i have into it great. There has been alot of hours spent to get to this point. If it doesnt sell , It will be a nice christmas present for me. we stoped working on it due to needing a new crank for the engine that we have now & it just got too hot. 
 
Please ask questions if interested. i'm not interesrted in selling any parts. just everything i have for the car that came with it or i have pictured or mentioned . alot of the dirty hard work is done .  Pictures of all progress are included & can be emailed . comes with dealer invoice origional CA title from 1968 might come with origional CA 1968 tags if the origional owner can find them. says in attic & its too hot to find them.

The frame was straightened recently. - so its prefectly straight now. the passenger rear inner wheel well took a hit in its life & was replaced thats why frame straightening was needed- front cowl passenger side has some minor bends from another fender bender (not too noticable) but i didnt repair that bcz you cant see it with the grill & everyting

This is my project & my chevelle in parts & pieces located in vegas buyer to pick up or have shipper be aware in-op & might not be able to fit both engines & parts in the car? so buyer covers all shipping

Auto Services in Nevada

Wide Guys Batteries & Auto Parts ★★★★★

Automobile Parts & Supplies, Automobile Manufacturers & Distributors
Address: 1230 W Owens Ave, Las-Vegas
Phone: (702) 566-0616

Wicked HP ★★★★★

Auto Repair & Service, Automobile Repairing & Service-Equipment & Supplies
Address: 6160 N Hollywood Blvd # 103, Nellis-Afb
Phone: (702) 708-1072

Trimline of Reno ★★★★★

Automobile Parts & Supplies, Truck Accessories, Automobile Customizing
Address: 1660 Greg St, Lockwood
Phone: (775) 322-3181

Titan`s Auto Sales ★★★★★

Used Car Dealers
Address: 1431 S Main St, Las-Vegas
Phone: (702) 457-8500

Tirexchange Las Vegas ★★★★★

Automobile Parts & Supplies, Tire Dealers, Tires-Wholesale & Manufacturers
Address: 7575 W Sunset Rd Ste 150, Sandy-Valley
Phone: (702) 364-2201

Tire Works Total Car Care ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Tire Dealers
Address: 8825 W Flamingo Rd, Blue-Diamond
Phone: (702) 736-6700

Auto blog

2013 Chevy COPO Camaro announced with two new engines and manual option

Thu, 07 Mar 2013

Chevrolet is following up the 2012 COPO Camaro with another limited run of the drag-strip-ready production car for 2013. Ditching the superchargers, the 2013 COPO Camaro can only be equipped with one of three naturally aspirated V8 engines, and other new features include the option of a manual transmission, new front springs, some minor styling changes and a lower starting price of $86,000. All cars are designed to abide by the rules of the NHRA's Stock Eliminator or Super Stock classifications, depending on in which series buyers wish to enter their Chevrolet Camaro.
Returning for 2013 is the 427-cubic-inch V8 producing 425 horsepower, but the new engines include a 325-hp 350-CID V8 and a 375-hp 396-CID V8. Buyers can select to purchase all three engines, and each will be matched with the sequence number of that car; the track-only COPO cars will not have vehicle identification numbers and can't be registered for street use.
Chevrolet is also offering unique enthusiast-specific options such as a COPO Build Book and the opportunity for owners to help assemble their car's engine at the Chevrolet Performance Build Center in Wixom, MI.

GM won't sell 2014 Chevrolet SS in Canada

Thu, 21 Feb 2013

Allow us to be the first to extend our condolences to our friends to the north. General Motors has announced the 2014 Chevrolet SS will not be available in Canada. The Globe and Mail reports the automaker has confirmed the high-performance sedan won't hit Canadian dealers, though GM hasn't offered up any reasoning as to why that is.
Buyers here in the US of A, meanwhile, can look forward to getting their hands on the 415-horspower, rear-wheel drive SS by late summer. Something tells us it won't be long after that before Canadian officials start seeing individually imported 6.2-liter V8 four-doors in their neighborhoods. Fortunately, Canadian buyers will still be able to take home the 2014 Chevrolet Corvette. The C7 bowed at the Canadian International Auto Show last week, reportedly drawing sizable crowds and interest.

2014 Chevrolet Corvette Stingray convertible headed for Geneva debut

Mon, 28 Jan 2013

While most of the world is still coming down from all the hype surrounding the debut of the 2014 Chevrolet Corvette Stingray at the Detroit Auto Show earlier this month, we're already looking to the future. And according to Autoweek, the next chapter in the C7 story will unfold at the Geneva Motor Show in March. That's right, General Motors is reportedly using the Swiss stage as its venue to debut the Corvette Stingray convertible.
If this strikes you as odd, you aren't alone. After all, with a car that's such an American icon, we'd fully expect Chevrolet to unveil it here on our shores in either Chicago or New York. But according to Autoweek, GM is looking to boost export sales of its halo car, and since the C7 was engineered to compete with the world's best and brightest, showing it off in Geneva is somewhat of a smart move. What's more, those with sharp memories will recall that GM used the Geneva expo to debut the sixth-generation C6 Corvette convertible back in March 2004, so there's also a precedent.
Details surrounding the Corvette Stingray convertible are still slim, though we fully expect the 6.2-liter V8 and choice of either six-speed automatic or seven-speed manual transmissions to carry over unchanged. Prototypes spotted on the road showed the car fitted with a cloth convertible roof, as well.