1957 Chevrolet Bel Air150210 on 2040-cars

Auto blog

C7 Corvette turbo with 1,000 horsepower promised from Hennessey

If you can't wait for the next-generation Chevrolet Corvette ZR1, Hennessey says they will have you covered. The Texas-based company has announced it will offer a spate of upgrades for the 2014 Corvette ranging from a range of bolt-on options all the way up to a 1,000-horsepower, twin-turbo system. Buyers can start with a cold air intake, cat-back exhaust or stainless steel long-tube headers, but Hennessey says it will also offer up three stages of forced induction mayhem should those bits and baubles not provide enough thrust.
Those choices start with a supercharger system good for up to 700 hp, though Hennessey will gladly ditch the blower in favor of two turbos. Doing so will spin the crank to the tune of 800 horsepower all the way up to a certifiably ludicrous 1,000 ponies. There's no word on how much these tricks will cost you - or when they will be available, as we're guessing they haven't gotten their hands on the car yet - but you can head over to the Hennessey site to drop them a line if you're curious.

Chevrolet planning low-cost Corvette under Stingray?

If you're burnt out on musings about the Chevrolet Corvette, you'll want to go ahead and skip this post. Motor Trend reports General Motors is hard at work on a low-cost version of the seventh-generation sports car for 2015. Rumored to be called the Corvette Coupe, the car will forgo the Stingray and skip the 450-horsepower 6.2-liter V8 engine in favor of a 5.3-liter V8 with under 400 ponies. If you're keeping track, that's a shade of the same engine found behind the headlights of the 2014 Chevrolet Silverado and GMC Sierra.
The report also suggests the Coupe will receive a number of aesthetic tweaks to separate it from the Stingray, including different front and rear fascias as well as new front fenders and a rear diffuser. Motor Trend says the point of all this is to cut the car's price tag, which means we may see a Corvette on showroom floors for less than $50,000 if this car comes to fruition.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.